Trex 600 esp setup




















H Torque tube front drive H Torque tube rear drive gear. H Torque tube bearing holder. H Bearing 4 pcs12x18x4. H New Landing skid black. H Landing skid yellow. H Landing skid orange. H Carbon tail blades 95mm. H Skid pipe black 2 pcs. H One way bearing shaft. H Pinion 10T.

H Motor pinion 11T. H Torque tube drive gear set. H Canopy nut. H Tail control guide 4 pcs. H Flybar control rod. HMetal main shaft bearing H Tail rotor hub. H Screw main blades. H Main shaft set. H Pinion gear 14T.

H Pinion gear 15T. H Pinion gear 16T. H Main shaft. H Main blade screws. Tony Administrator Staff member. Yup, the thread linked above will work just fine. Everything will be the same except the gyro as Lee posted. Tony said:. With the DX8 you have three They are great. I'm going to order some new bearings from them soon. Good luck with the maiden. You better get it on film. Yup, what Lee said.

Same for the gyro, we have 3 positions and the 6i only has two. Ok guys I understand. Articles New articles New comments Search articles. Log in Register.

Search titles only. Search Advanced search…. New posts. Search forums. Log in. Install the app. Hey Guest, I see you are not signed up on our forum yet. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser. It may not display this or other websites correctly. Save for later Your wishlist has been temporarily saved. Hobby Squawk Community Forum visit forum.

RC Knowledge Blog visit blog. Continue to the European site. Stay on the US site.



0コメント

  • 1000 / 1000